343 45&1 R#FMU 3FQMBDFNFOU _)FBE %SJWF_ 5IF CFMU SPUBUJOH EJSFDUJPO JT QSFTDSJCFE 3FQMBDF UIF CFMU XIJMF PCTFSWJOH UIF BSSPX QSJOUFE PO UIF CBDL side of the belt matching the direction of the rotation. Place a mark to note the existing tension condition. Do the same for the other side. 45&1 Slightly loosen 4 pulley holder mounting screws. (Take caution that the pulley may fall off if the screws are completely loosened.) Do the same for the other side. 45&1 &Applicable P/N: SVKA, SVKB 2#FMU .FBOEFSJOH "EKVTUNFOU _)FBE %SJWF_ &Applicable P/N: CVGA, CVGB, SVKA, SVKB (CVGA in photo) & The belt will be stretched with use. Perform maintenance on a periodic basis. First, loosen a nut on the tensioning screw, and gradually tighten the tension screw. If tighten excessively the unit will creep to the opposite side, then loosen. 45&1 Meandering will gradually disappear. Re-tighten the screws to complete. The belt will come to a stable state by leaving the conveyor in operation for a while after the adjustment. 45&1 While the belt is meandering to one side, start the conveyor. The meandering adjustment is done with the tensioning screw on the side the belt is deviated to. &Make sure to avoid contact of the side surface of the belt. Loosen the tensioning screws and completely remove. Do the same for the other side. 45&1 Push both pulley holders towards the main body. 45&1 Confirm the belt rotation direction and replace the belt. 45&1 Tighten the tensioning screws (2 on both sides) to the position marked in Step 1 to adjust the tension. Perform this adjustment while checking for the parallelism between the pulley holder and the aluminum frame. 45&1 Completely tighten 4 pulley holder screws. Tighten the 4 screws on the other side completely to complete. 45&1 Mark Tensioning Screw Belt Removal Direction Conveyor Belt Replacement Procedure
RkJQdWJsaXNoZXIy MTc2MTk0OA==