When nonstandard dimensions are entered in the design window for components imported from RAPiD Design(inCAD Components), an error message is displayed, but you can "Apply to the CAD model." However, you cannot use RAPiD Design(inCAD Components) "Save with part number." Use SOLIDWORKS "Specify save location" instead.
- MISUMI Top Page>
- RAPiD Design(inCAD Components) Support>
- Frequently asked questions>
- 4-5 How can I save the file even though the part is a nonstandard state?
RAPiD Design(inCAD Components) Support
Frequently asked questions- About file saving
4-5How can I save the file even though the part is a nonstandard state?
Frequently asked questions
About file saving
- 4-1How can I add a specific string before or after the file name?
- 4-2How can I change the file name?
- 4-3How can I specify the file save location?
- 4-4When I make changes to dimensions and specifications in RAPiD Design(inCAD Components), will the original file be overwritten with the edited file?
- 4-5IHow can I save the file even though the part is a nonstandard state?
- 4-6Can I use "Pack & Go"?
- 4-7What is a file with the name "BaseModel~"?
- 4-8How can I use the same component in a different size?
About technical information
About mates and constraints
- 4-10When mates and constraint components are edited in RAPiD Design(inCAD Components), are the mates and constraints transferred?
- 4-11Can I save components imported with mates and constraints separately with RAPiD Design(inCAD Components)?
About assembly
- 4-12Can specifications and dimensions be changed in the assembly file?
- 4-13How do I save a part or assembly file?
About configuration
About performance (operating speed)
About properties
About the operating environment
Precautions for use
- 4-18Why is there a discrepency between the model and part number?
- 4-19Why is the model recognized as a "Not standard parts"?
- 4-20Are the specific materials set for parts and assemblies?
- 4-21What happens if I delete features in SOLIDWORKS?
- 4-22Can I change dimensions using the Hole Wizard?
- 4-23What are the differences between "Apply to CAD model" and "Save with part number"?
- 4-24Why is there no fine screw thread shown in RAPiD Design(inCAD Components)?
- 4-25Why are there specific dimensions required for some alterations?
- 4-26What does the "Older Version File" warning means?
- 4-27Which software version shall I use?
- 4-28What does the message "Information relating to the model" means?
- 4-29Is it possible to double log in?
- 4-30Is it possible to run multiple instances of SolidWorks simultaneously?
- 4-31What is the problem if nothing is showing up on the startup screen of RAPiD Design(inCAD Components)?
Copyright © MISUMI Corporation All Rights Reserved.